Bubble film machine common faults and solutions

First, the bubble film is unstable
1. Possible causes: There are impurities at the inlet and outlet of the bubble film or the core of the bubble film is loose.
2. Solution: Clean up the impurities and roll the core tightly, and adjust the tension of the bubble film appropriately.
Two, circuit board failure
1. Possible cause: The circuit board is stimulated or flooded, resulting in short circuit or open circuit.
2. Solution: Replace the circuit board or repair.
3. Motor failure
1. Possible reasons: the quality of the motor is not good, or it is used for a long time.
2. Solution: Replace the motor or repair.
Fourth, the heat seal is not strong
1. Possible cause: insufficient temperature or pressure.
2. Solution: Increase the temperature or pressure, and appropriately increase the heat sealing time.
Five, rubber roll deviation
1. Possible cause: The assembly is not firm or the use time is too long.
2. Solution: reassemble or replace the roller.
Six, the bubble film junction is not strong
1. Possible cause: Improper operation or dirty interface.
2. Solution: Strengthen the operation specification, clean the interface regularly and increase the firmness with tape.
The above is the common faults and solutions of the bubble film machine, I hope the reader can find and solve the fault of the bubble film machine in time during use, and make better use of the bubble film machine.