How To Prevent The Bubble Film Bag Making Machine

How to prevent the bubble film bag making machine? In order to make the work efficiency of the bubble film bag making machine more high, we should do the corresponding preventive work before using the bubble film bag making machine to avoid equipment failure and unable to continue operation. Affect the production efficiency, let's take a look at it!

The bubble film produced by the bubble film bag making machine can effectively protect the product, so it has been widely used in many industries, because the bubble film has good performance, it can provide good protection for all kinds of products, and high-quality bubble film is often made by using the bubble film bag making mechanism, how to solve the fault in the production process? How do we prevent it? The bubble film bag making machine should be designated to operate, do not allow the extruder screw without material idling, so as not to scratch the screw and the barrel. After stopping, if there is material in the barrel, before starting again, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the heat preservation can be started for more than 30 minutes, it is strictly prohibited to start before the temperature does not meet the requirements, so as to avoid damage to the parts. When the air cushion film machine is fed in the hopper, it must be clean and strictly prevent metal debris, sand and small tools from entering the feed port to prevent damage to the cylinder and screw. If abnormal sound is found during operation, it should be stopped immediately for processing. In order to avoid this failure, it is very important for us to do a good job in the maintenance of the bubble film bag making machine. The screw of the air cushion film machine is removed from the barrel for some reason, and should be properly handled to prevent deformation. If it is not installed back into the barrel for a long time, the screw must be hung vertically to prevent collision, bending and permanent deformation. The surface of the barrel and screw are coated with anti-rust oil for protection. After the bubble film bag making machine is stopped, if there is material in the barrel, before starting again, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the heat preservation can be started for more than 30 minutes, it is strictly prohibited to start before the temperature does not meet the requirements, so as to avoid damage to the parts. The bubble film bag making machine is regularly repaired, the die head is thoroughly cleaned every three months, the grease of various bearings is replaced, the lubricating oil of the reducer is replaced every six months, and the whole equipment is overhauled every two years.

The above is the introduction of the preventive work of the bubble film bag making machine.