The operation process of bubble film machine and the problems that should be paid attention to during inspection

Bubble film machine is a well-known packaging artifact in the rapid development of the express industry. As more and more people see business opportunities in this industry, there have been many entrepreneurial bubble film machine manufacturers in recent years, and the demand for bubble film machines is growing. Many manufacturers may not be familiar with the use of bubble film machine steps, today to share.

Bubble film machine correct operation process:

1. Before starting, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and can be started for more than 30 minutes. Do not start before the temperature does not meet the requirements, so as not to damage the bubble film machine.

2. The products produced by bubble laminating machine are moisture-proof, shock-proof, sound-proof, beautiful, insect-proof, mildew proof and cheap. Therefore, when feeding in the hopper, it must be kept clean and strictly prevent metal debris, sand and small tools from entering the feeding port, so as not to damage the cylinder and screw. If any abnormal noise is found during operation, it should be stopped and dealt with immediately.

3. Check whether the temperature control of the bubble film machine is good, whether the heating device is intact, and whether the temperature at each point is within the target range to ensure the normal operation of the machine.

4. Observe whether the thickness of the film is uniform and whether the folding diameter meets the standard. If not, it needs to be replaced.

5. Regular maintenance, thoroughly clean the bubble film machine every three months, and replace the grease of various bearings every three months.

Then, before the bubble film machine equipment is produced, we need to check and do a good job to ensure that it is in good condition. What do you generally need to pay attention to when checking the bubble film machine?

1, check whether the temperature control and heating appliances are in good condition, pay attention to timely adjust the heating temperature of each point within the range of indicators. The pressure of the gas tank should not be too high, but there should be a backup pressure.

2. Check and control the proportion of raw materials, stir evenly, pull speed, and control film thickness.

3. Regularly check the temperature rise and mechanical transmission of the motor running the air bubble film machine, as well as the lubrication of the reducer and air compressor cylinder oil.

4. Check whether the raw materials have impurities, especially the iron mixed with magnets should be checked in time.

5. Observe and adjust the uniformity of film thickness, and the folding diameter meets the standard. When the die of the bubble laminating machine is uniform, you can wear gloves and slowly lift the tube blank. At the same time, the end of the tube blank is closed, and a small amount of compressed air is passed into the center hole of the mandrel. It is then carefully guided through the bubble stabilizer and herringbone plate, then through the traction roller and guide roller until it is wound. Only in this way can we make better use of the bubble laminator, extend its service life and create more profits.